Introducing Furniture & Effect Wax, from the 1829 Vintage Collection.


Furniture & Effect Wax is perfect for use over Chalky Emulsion to protect and enhance your upcycled furniture. Its also ideal for giving a protective seal over Artisan Concrete Effect or Rust Effect.  It’s easy to apply and dries to a deep lasting shine which repels water and protects against scuffing and stains.  Furniture & Effect Wax is water repellent but not recommended for areas with lots of water.


Ensure the surface that you are waxing is clean, dry, smooth and free from dust. If necessary sand the surface to smooth out any bumps or scrapes. If applying over Chalky Emulsion, ensure that the surface has been given two coats of paint and has been left to dry for an adequate amount of time. To achieve a vintage, aged look, you can also sand some of the edges.


Apply using either a soft paint brush or a lint free cloth. Work the wax into the paint, or grain if applying directly to wood, a little at a time, making sure not to apply too much. If applying in a cold temperature you may benefit from heating the wax slightly to soften first. Once the surface is covered, leave to dry for ten minutes and then buff the surface to a shine using a fresh clean cloth, removing any excess wax as you work. Leave the wax to dry for fifteen minutes before moving or using the furniture. For a greater shine, further applications can be applied in the same way after rubbing down with soft to medium wire wool.  Vintage wax can be reapplied over time to enhance protection and finish and provide a greater shine.


Approximately 7 square metres per 500ml tin.


Furniture & Effect wax dries in approximately fifteen minutes. 


Clean equipment after use by removing excess wax and soaking in white spirit, then wash with warm soapy water.

View 1829 Furniture & Effect Wax